× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  • Subject: Re: Inventory Month End Close
  • From: Chuck Lewis <clewis@xxxxxxxxxx>
  • Date: Wed, 02 Feb 2000 14:02:30 +0000

Roger,

Ending QCMN when using C/A doesn't kill your job too ?

It is a LOT easier to just add the Work Station Name into the subsystem 
description
for QINTER2 and then when the QINTER subsystem goes down, they come up in the
QINTER2. No need to do all that disconnecting and reconnecting. They need to 
either
signoff prior to ending QINTER or have them do a TRFSECJOB into QINTER2... If 
you
don't want them to NORMALLY be in QINTER2 and QINTER2 is not NORMALLY active, 
you
can schedule a job to ADDWSE and STRSBS and then another to RMVWSE at ENDSBS...

FYI !

Chuck

rhamberg@mother-parkers.com wrote:

>      We use to have the same problem, so I created a second subsystem call
> qinter2. You can end subsystem QCMN and Qinter at monthend then have your I.T.
> people add a device description to the work station entry for Qinter2. 
>Assuming
> you are using client access, you can then click on communications on your task
> bar then click disconnect. Next click communications again then click 
>configure
> and enter the device description  set up in Qinter2 by I.T. in the workstation
> box
> and click OK. Next click on communications again and connect. this should set 
>up
> a workstation setting in Qinter2 only you
> can log onto. (unless someone else is using the devise ID) I renamed a couple 
>of
> virtual devise desc. and always log onto these. Hope this helps......
>      If you need further clarification, I can be reached at 905-279-9100.
>
>      Roger
>
> +---
> | This is the BPCS Users Mailing List!
> | To submit a new message, send your mail to BPCS-L@midrange.com.
> | To subscribe to this list send email to BPCS-L-SUB@midrange.com.
> | To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner: dasmussen@aol.com
> +---

+---
| This is the BPCS Users Mailing List!
| To submit a new message, send your mail to BPCS-L@midrange.com.
| To subscribe to this list send email to BPCS-L-SUB@midrange.com.
| To unsubscribe from this list send email to BPCS-L-UNSUB@midrange.com.
| Questions should be directed to the list owner: dasmussen@aol.com
+---

As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.