Re: Delay in saving -- WDSCI-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

On 9/27/21 11:53 AM, (WalzCraft) Jerry Forss wrote:

I just started using a new version of RDi (Version: 9.6.0.10
20210202_0642) and something odd is happening.

I do a ctrl/s to save source and jump to my PDM session to compile.
(Yes, I know about compiling through RDi but we use scott's
preprocessor to add commands in comment section) The compile does NOT
contain my changes. If I wait to say 15 seconds and compile again
the changes are there.

Is there a setting in the new version to force the changes to disk
immediately?

Are you connected via a VPN?

As Scott mentioned, it takes a few seconds for source to be uploaded to the host. I only started experiencing this when I regularly used RDi over a VPN connection.

Just wait for the Synchronizing Resources message in the status bar to clear and your source will be fully uploaded and ready to compile.

IF you were using the normal RDi compiler function, you could hit shift-ctl-c to save & compile. In this case it would automatically wait for the synchronization process to complete.

david

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.