Delay in saving

Hi All,

I just started using a new version of RDi (Version: 9.6.0.10 20210202_0642) and something odd is happening.

I do a ctrl/s to save source and jump to my PDM session to compile. (Yes, I know about compiling through RDi but we use scott's preprocessor to add commands in comment section)
The compile does NOT contain my changes. If I wait to say 15 seconds and compile again the changes are there.

Is there a setting in the new version to force the changes to disk immediately?





Subject to Change Notice:

WalzCraft reserves the right to improve designs, and to change specifications without notice.

Confidentiality Notice:

This message and any attachments may contain confidential and privileged information that is protected by law. The information contained herein is transmitted for the sole use of the intended recipient(s) and should "only" pertain to "WalzCraft" company matters. If you are not the intended recipient or designated agent of the recipient of such information, you are hereby notified that any use, dissemination, copying or retention of this email or the information contained herein is strictly prohibited and may subject you to penalties under federal and/or state law. If you received this email in error, please notify the sender immediately and permanently delete this email. Thank You

WalzCraft PO Box 1748 La Crosse, WI, 54602-1748
www.walzcraft.com<http://www.walzcraft.com> Phone: 1-800-237-1326