Re: RDi 9.6.0.5 debug is "supposed to be useful"...

OH well, open an IBM PMR# 04864,442,000 for this issue: RDi 9.6.0.5 unable to add Break-Points.

I attached the saved-error-log before doing the restarts, -clean, clear cache, remove break-points/Monitor, etc...

Oh well, I followed protocol and open a PMR for this issue.


-Ken Killian-


-----Original Message-----
From: Ken Killian
Sent: Tuesday, January 22, 2019 12:16 PM
To: (wdsci-l@xxxxxxxxxxxxxxxxxx) <wdsci-l@xxxxxxxxxxxxxxxxxx>
Subject: RE: RDi 9.6.0.5 debug is "supposed to be useful"...

Clear cache, -clean and restart cleared my errors! :)

I can once again add breakpoints in RDi again! :)

-Ken Killian-


-----Original Message-----
From: WDSCI-L <wdsci-l-bounces@xxxxxxxxxxxxxxxxxx> On Behalf Of Ken Killian
Sent: Tuesday, January 22, 2019 11:41 AM
To: Rational Developer for IBM i / Websphere Development Studio Client for System i & iSeries <wdsci-l@xxxxxxxxxxxxxxxxxx>
Subject: [WDSCI-L] RDi 9.6.0.5 debug is "supposed to be useful"...

Hi,

Trying to debug with RDi 9.6.0.5 and add a break-Point. I did about 20-clicks, and the break-point does not get set... <counting to 100>

Decide I am STUPID and do not how to use my mouse. <sigh>

Then decide to check the error-Log, and I see this error:
[main]PICLDebugPlugin$3Hidden message : DBGP0004E Program terminated.

Time to do recover again...


1.) clear cache

2.) remove all break-points/Monitors

3.) close RDI

4.) Start RDI with "-clean"

5.) Close RDI

6.) Start RDI normally, without "-clean"

7.) Mumble to myself "What a Great Productivity" I have with RDI...
While breathing into a paper-bag...

Oh well, it happens... I need to get used to it, and lower my expectations... <sigh>

Is it even worth it to try to open an PMR, when I can't EVERY duplicate strange behavior? Probably not worth the PMR hassle.

<Break Time!>

-Ken Killian-