Re: Setting library list using Initial command

I do the same thing, works fine and changes the library list of the job in
which all the work is done, as you are wanting. My dumb little tool stores
and "restores" library lists, so I can use it from the command entry window
when I switch projects while connected (like SETLIBL LIBL(PAYROLLDEV)). I
use only a single connection.

Buck's right, the initial command only runs during initial connection (just
like your initial program on a profile only runs when you begin a job).

Stu




On Tue, Nov 18, 2014 at 8:58 AM, Buck Calabro <kc2hiz@xxxxxxxxx> wrote:

On 11/18/2014 9:32 AM, Frank Broome wrote:

I am trying to set up a library list using Initial command in

Properties->Subsystems.

The program runs fine and it looks like it's doing what it should

however my RDi session library list does NOT change!

It seems like it runs the Initial command in a separate job instead of

running "interactively" for my session.

Setting the library list using CHGLIBL in "Initial command" works fine,

which makes me a bit confused.

Any help or advice is highly appreciated!

Disconnect and reconnect your Connection. The initial command is only
run when the Connection is first started.

--
--buck

'I had nothing to offer anybody except my own confusion' - Jack Kerouac
--
This is the Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries (WDSCI-L) mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.