Re: RDp 8.0.3 Upgrade and LPEX Issue

I've noted this behavior as well. I checked the feature in the Preferences section (under Remote Systems, Remote Systems LPEX Editor, IBM i Parsers, ILE RPG, and the checkbox for Automatic Closure of control block should be checked). It is on mine. Either it's in another section of Preferences (which wouldn't make sense), or there is a bonafide issue that should be reported to IBM. (Unless there's a reason it was removed...)

-- Ken

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On Behalf Of Robert J. Mullis
Sent: Tuesday, October 25, 2011 12:52 PM
To: Websphere Development Studio Client for iSeries
Subject: [WDSCI-L] RDp 8.0.3 Upgrade and LPEX Issue

I just recently upgraded to 8.0.3 and have found an aggravating issue in the LPEX editor. Before the upgrade for example, I was able to enter the opcode SELECT and when I pressed enter the ENDSL opcode would be entered automatically on the next line. Since the upgrade to 8.0.3, it will not do it. It still works for IF statements and DO loops, but it won’t for SELECT and MONITOR statements. There may be other opcodes that have the same issue and I just haven’t encountered them yet.

Is anyone having the same problem?

Thanks,
Robert J. Mullis
Wellington-Royce Corporation
(770) 395-7400 x1023