Re: Connecting to a V4R4M0 ?

Perhaps you want to give RPG Next Gen Editor
(http://rpgnextgen.sourceforge.net) a try if you don't want to go back
to SEU. I can't guarantee that it will work on V4R4 but it has no check
for supported/unsupported VRMs.

Regards

Mihael


-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of nb@xxxxxxxxxxxxx
Sent: Tuesday, December 22, 2009 10:10 AM
To: wdsci-l@xxxxxxxxxxxx
Subject: Re: [WDSCI-L] Connecting to a V4R4M0 ?

Il 15/12/2009 16.23, DeLong, Eric ha scritto:

I don't think there is support for WDSC to V4R4, but if it doesn't

work,

you could always just use CODE/400. That product was fully supported

in

V4. You should try WDSC first, though.

Thanks to all. Tried to connect with WDSC, and, after some trouble (bad
IP/default gateway set), i must give up as it gave me "Unsupported VRM"
and get Java excpetion when it try to start RSE.

I wasn't able to found the prerequisite page fro WDSC6 on the IBM site
(really, didn't search too much, but i don't see any indication on WDSC
page) so at least i gave up and use WDSC on the 5.4.0 box and then
transfer source to the 4.4.0 machine via FTP. It wasn't that bad,
considering that i have to compile in the 440 box to get error.

Just loosing time switching back to the prod box, do modification, send
to 440 box, recompile, test for error, and go on.