Re: Connecting to a V4R4M0 ?

I don't think there is support for WDSC to V4R4, but if it doesn't work,
you could always just use CODE/400. That product was fully supported in
V4. You should try WDSC first, though.

-Eric

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of nb@xxxxxxxxxxxxx
Sent: Tuesday, December 15, 2009 8:36 AM
To: wdsci-l@xxxxxxxxxxxx
Subject: [WDSCI-L] Connecting to a V4R4M0 ?






Hello to all.

Due to some problem, i have the need to rewrote a software i have for
5.4.0
on a 4.4.0 machine.

Does anyone know if it's possible to connect with WDSC (i'm using 6.0.1)
to
that box?? or do i have to switch back to SEU??

I don't care even if i cannot use WDSC to check source (i suppose 4.4.0
won't be considered by WDSC) but at least i would like to avoid to write
source on my 5.4.0 machine using WDSC, then copy to 4.4.0 to compile and
test (too much used to WDSC, programmin in SEU is slower...)

Any hint would be appreciated, just to avoid spending time trying to do
an
impossible connection.

Thanks

--

Nicola Brion