Re: Connecting to a V4R4M0 ?

It has been awhile since I connected to my V4R4 box, (its powered down
or I would try it) but from what I remember, I used WDSC V7 to connect
to it. I was able to write the routines and compile. The LPEX editor
simply didn't tell me when I tried to use an unsupported option.

The piece that is not there is the STRRSESVR on the emulator side.

So if memory serves, you can develop that way.

Sharon Wintermute

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of DeLong, Eric
Sent: Tuesday, December 15, 2009 9:24 AM
To: Websphere Development Studio Client for iSeries
Subject: Re: [WDSCI-L] Connecting to a V4R4M0 ?

I don't think there is support for WDSC to V4R4, but if it doesn't work,
you could always just use CODE/400. That product was fully supported in
V4. You should try WDSC first, though.

-Eric

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx]
On Behalf Of nb@xxxxxxxxxxxxx
Sent: Tuesday, December 15, 2009 8:36 AM
To: wdsci-l@xxxxxxxxxxxx
Subject: [WDSCI-L] Connecting to a V4R4M0 ?






Hello to all.

Due to some problem, i have the need to rewrote a software i have for
5.4.0
on a 4.4.0 machine.

Does anyone know if it's possible to connect with WDSC (i'm using 6.0.1)
to
that box?? or do i have to switch back to SEU??

I don't care even if i cannot use WDSC to check source (i suppose 4.4.0
won't be considered by WDSC) but at least i would like to avoid to write
source on my 5.4.0 machine using WDSC, then copy to 4.4.0 to compile and
test (too much used to WDSC, programmin in SEU is slower...)

Any hint would be appreciated, just to avoid spending time trying to do
an
impossible connection.

Thanks

--

Nicola Brion