×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
We have V5R4 box and using WDSC 7.0, and it happens also to us, but if I
Remove Service Entry Point and then Set Service Entry Point again it works
again.
Thanks,
Jeff Buening
message: 1
date: Wed, 02 Dec 2009 14:12:32 -0600
from: David Gibbs <david@xxxxxxxxxxxx>
subject: [WDSCI-L] Debug getting lost?
Ok, is it just me ... or does SEP Debug in RDI 7.5 sometimes lose it's mind
and not activate?
I've found it happens after I've been using RDI for a while (although
sometimes as little as 20 minutes).
Basically, I set a service entry point debug and invoke the program (on
green screen), but the SEP never hits.
This happens even after I've signed off and on again.
It doesn't help even if I right click on the SEP table entry and select
refresh.
The only way I can get SEP Debug to work again is to shut down RDI and
start it back up.
Any ideas?
Thanks!
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
