×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
For me, I was able to get the SEP Debug to stop the first time through, but not the second time after that.
My "work around" is to do the following within the Debug Perspective and under the Debug Tab (window):
- Terminate (red box icon) any threads that may still be open.
- Remove All Terminated Launches (dbl XX icon) on the "Platform: IBM I Connection xxxxxx".
Tim Sorensen | Senior Software Engineer, ERP LX Development | Infor | timothy.sorensen@xxxxxxxxx
-----Original Message-----
Ok, is it just me ... or does SEP Debug in RDI 7.5 sometimes lose it's mind and not activate?
I've found it happens after I've been using RDI for a while (although sometimes as little as 20 minutes).
Basically, I set a service entry point debug and invoke the program (on green screen), but the SEP never hits.
This happens even after I've signed off and on again.
It doesn't help even if I right click on the SEP table entry and select refresh.
The only way I can get SEP Debug to work again is to shut down RDI and start it back up.
Any ideas?
Thanks!
david
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
