In all my configurations, I set my *CURLIB in my user profile. Can you
set the current library at the beginning of the CL command, or even in your
user profile?
Buck,
Thanks for your input. I clicked on the library list within WDSC and did
a Change Current library to ISPO56A which is where the EVFEVENT file
resides. Also, in the CL program, immediately after the in-house routine
that sets the library list, I do a CHGCURLIB CURLIB(&OBJLIB). Just for
good measure, I do this again immediately before and after CRTCBLPGM. Still
nothing in Error List.
Rod
Please consider the environment before printing this email.
This message, including any attached documents, is intended for the
addressees only. It may contain information that is confidential,
privileged and/or exempt from disclosure. No rights to privilege or
confidentiality have been waived. Any unauthorized use or disclosure is
prohibited. If you have received this message in error, please reply to the
sender by e-mail and delete or destroy all copies of this message.
______________________________________________________
Avant d'imprimer ce courriel, pensez à l'environnement.
Ce message, incluant tous les documents joints, est à l'intention des
destinataires visés seulement. Il peut contenir des renseignements
confidentiels, protégés et/ou ne pouvant pas être divulgués. Aucune
renonciation n'est faite quant à sa nature confidentielle et privilégiée.
Par conséquent, toute diffusion ou utilisation non autorisée est
strictement interdite. Si vous avez reçu ce message par erreur, veuillez
en aviser immédiatement l'expéditeur par retour de courriel et en détruire
toutes les copies existantes.
midrange.com
