×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Are you recompiling the program inbetween calls? You need to refresh the
SEP each time after a compile. If that doesn't work you will need to
completely shut down WDSC and restart it. I have the same issue where if I
do a SEP debug at let's say 8am and then don't do another till 9am, it
doesn't pick up the SEP, even if I refresh and/or re-add the SEP. I have
even tried stopping and restarting the debug servers with no success.
Completely restarting WDSC is the only thing that fixes it.
HTH,
Aaron Bartell
http://mowyourlawn.com
-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On
Behalf Of Andy Devine
Sent: Friday, February 08, 2008 3:15 PM
To: WDSCI-L@xxxxxxxxxxxx
Subject: [WDSCI-L] Debugging v7.0 SEP will not stop in second call to
program.
The following is condensed version of a COBOL program.
PROCEDURE DIVISON.
CALL 'programname'
MOVE
MOVE
IF
Whatever
CALL 'programname' (same name as first call)
I can set a SEP on 'programname' and WDSC will stop and pull up DEBUG
session. I can look at variables, setup breakpoints, and do whatever I need
to do. After I leave first call I would expect to stop at second call (with
SEP) to the program, but WDSC does not stop. The originating programs ends.
Has anyone seen this situation?
Andy Devine
800-707-6422 Ext 843
andyd@xxxxxxxxxxx
midrange.com
