RE: Permanent I/O Error occured to DSPF

["tim" <tim2006@xxxxxxxxxxx>]

Make sure program is compiled with source ... then do strdbg and hit F10 ...
run program... should stop at line with problem...

-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
On Behalf Of Charles Wilt
Sent: Wednesday, October 08, 2008 4:59 PM
To: RPG programming on the AS400 / iSeries
Subject: Permanent I/O Error occured to DSPF

All, I'm getting an error during I/O to a display file:


RNQ1251

Message . . . . :   Permanent I/O error occurred in file FV011RP (C G D F).
Cause . . . . . :   RPG procedure FV011R in program HLTHCURRLS/FV011R at
  statement 11288 detected a permanent (not recoverable) file, session, or
  device error. The session, device and/or program has been stopped. Examine
  the major/minor return code value to determine the specific error that
  occurred. If the major return code is 80 then a system or file error
  occurred and programmer action is required to fix the problem. If the
major
  return code is 81 then a session or device error occurred, but use of
Technical description . . . . . . . . :   The major return code is 80. The
  minor return code is C0.

CPF5192
Message . . . . :   Data sent to device QPADEV001X not valid.  Negative
  response code is 10050129.
Cause . . . . . :   The condition was caused by the program output data
  containing below hex 40 or too many input fields.  More information on the
  negative response code can be found in either the IBM 5494 Remote Control
  Unit Functions Reference (under negative responses) or the SNA Formats
  Manual (under SENSE or LUSTAT codes).  Invalid data (below hex 40) may
have
  occurred in one of the following ways:
    Invalid parameter data passed in variable to command language program.
  Variable is used in SNDPGMMSG command.  Command fails when data is
  displayed.
    Hexadecimal characters below hex 40 entered into TEXT parameter of
create
  command.  Display command for object fails when object parameters are
  displayed.
    Data base record containing invalid data displayed by the application
  program.
    Failure to specify RSTDSP(*YES) when alternating displays from more than
  one file to the device, where both files have input fields.

I've looked at the dump, I don't see any invalid characters (< x'40').

I looked up the sense code and it says:
10050129 = Format table overflow

Does anybody have an idea of what's wrong?

Thanks!

Charles Wilt