RE: Two variables...one memory location

["Wilt, Charles" <WiltC@xxxxxxxxxx>]

The system is only doing what you told it to.

Post the d-specs that define the varibles being passed, the prototype and the interface for the
procedure, along with the actual call and we'll try to figure out what you did wrong.

Charles Wilt 
--
Software Engineer
CINTAS Corporation - IT 92B
513.701.1307

wiltc@xxxxxxxxxx


> -----Original Message-----
> From: rpg400-l-bounces@xxxxxxxxxxxx [mailto:rpg400-l-bounces@xxxxxxxxxxxx]
> On Behalf Of Chandra Krieg
> Sent: Monday, August 04, 2008 12:08 PM
> To: 'rpg400-l@xxxxxxxxxxxx'
> Subject: Two variables...one memory location
>
>
> I am calling a procedure that passes in 12 parameters.  Two of these parms
> are populated within the procedure and the new values are passed back to
> the calling pgm.  These two variables, when testing, are using the same
> memory address in the system.  As soon as one is assigned a new value they
> both are updated with the new value.
>
> I have changed the order of the parameters, re-compiled, logged off and
> other various means of trying to resolve the address issue.  Can anyone
> tell me why the system might be assigning these two variables the same
> memory location or a way to avoid this?
>
>
> Chandra Krieg
> i5 Programmer/Analyst
> RateWatch
> (P) 1.800.348.1831 ext 311
> (F) 1.920.568.1403
> www.rate-watch.com



This e-mail transmission contains information that is intended to be confidential and privileged.  If you receive this e-mail and you are not a named addressee you are hereby notified that you are not authorized to read, print, retain, copy or disseminate this communication without the consent of the sender and that doing so is prohibited and may be unlawful.  Please reply to the message immediately by informing the sender that the message was misdirected.  After replying, please delete and otherwise erase it and any attachments from your computer system.  Your assistance in correcting this error is appreciated.