Re: Program won't Compile

We had the same problem recently, with the same error.
Ours was due to somebody (the proverbial somebody) moving a service program
from one binding directory to another.
This was rectified by including the new binding directory in the H specs.



Alan Shore

NBTY, Inc
(631) 244-2000 ext. 5019
AShore@xxxxxxxx

rpg400-l-bounces@xxxxxxxxxxxx wrote on 12/14/2006 11:15:43 AM:

I can't figure this one out.  I made a minor programming change to an

RPGLE

program.  I set up my library list to compile it.  The compile fails.

The

spool file says:

Errors were found during the binding step. See the job log for more
information.

Ok so I go to the Joblog, like it says, and I see:

Message . . . . :   Job ended. Cancel message received at command

processor.

Cause . . . . . :   A message with a severity equal to or exceeding the

end

  severity was received at the command processor. Recovery  . . . :   See
the messages previously listed to determine the message that caused the

job

to be ended. Correct the errors, and then try the request again.

Unfortunately, there are no previously listed messages except the job
submitted message.  So, what's the problem??  The only thing I noticed is
that while the job was sitting on the qbatch subsystem, it was in LCKW

state

and I can't figure out why and neither the joblog or listing want to give

me

any helpful information.

Rick Weber  |  TOYS 'Я' US International

========================================================================
This email message is for the sole use of the intended recipient (s) and

may

contain confidential and privileged information. Any unauthorized review,
use, disclosure or distribution is prohibited. If you are not the

intended

recipient, please contact the sender by reply email and destroy all

copies

of the original message. To reply to our email administrator directly,

send

an email to EmailAdmin@xxxxxxxxxxxx
Toys "R" Us, Inc.

--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing

list

To post a message email: RPG400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.