Program won't Compile

I can't figure this one out.  I made a minor programming change to an RPGLE
program.  I set up my library list to compile it.  The compile fails.  The
spool file says: 

Errors were found during the binding step. See the job log for more
information. 

Ok so I go to the Joblog, like it says, and I see:

Message . . . . :   Job ended. Cancel message received at command processor.

Cause . . . . . :   A message with a severity equal to or exceeding the end

  severity was received at the command processor. Recovery  . . . :   See
the messages previously listed to determine the message that caused the job
to be ended. Correct the errors, and then try the request again.   

Unfortunately, there are no previously listed messages except the job
submitted message.  So, what's the problem??  The only thing I noticed is
that while the job was sitting on the qbatch subsystem, it was in LCKW state
and I can't figure out why and neither the joblog or listing want to give me
any helpful information.              

Rick Weber  |  TOYS 'Я' US International 

======================================================================== 
This email message is for the sole use of the intended recipient (s) and may
contain confidential and privileged information. Any unauthorized review,
use, disclosure or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and destroy all copies
of the original message. To reply to our email administrator directly, send
an email to EmailAdmin@xxxxxxxxxxxx 
Toys "R" Us, Inc.