RE: Subfile problem

["Smith, Mike" <Mike_Smith@xxxxxxxxxxxxxxxx>]

Sure, Here are the error codes.  RNX1255(session or device error)
CPF5066(SFLDSPCTL or SFLDSP option required for PUTGET)
Here is some code. 
 * LOAD THE SUBFILE THE FIRST TIME.
     C                   Exsr      $LOAD
     C                   Eval      PageNo = 1
     C                   DoW       Not F3Exit

      * CHECK TO MAKE SURE THAT AT LEAST 1 RECORD LOADED IN SUBFILE
      * THEN DISPLAY SUBFILE UNTIL COMMAND 3 PRESSED.

     C                   IF        Rrn > 0
     C                   Eval      SFLDSP = *ON
     C                   Else
     C                   Eval      SFLDSP = *OFF
     C                   EndIf

     C                   Exfmt     Test1
     C                   Write     MSGCTL1
     C                   Write     FOOT1
     C                   Exsr      $ErrorMSg
     C                   Exfmt     SCTL1


 
***********************************************************************
      *  LOAD  - LOADS 1 PAGE OF THE SUBFILE
 
**********************************************************************
     C     $LOAD         BegSr
     C                   Do        PageSize
     C                   If        Not $Next
     C                   Eval      EOF = *On
     C                   EndIf

     C                   IF        EOF = *On
     C                   Eval      SFLEND = *ON
     C                   Leave
     C                   EndIf

     C                   Eval      SFLEND = *OFF
     C                   Eval      Rrn  = Rrn + 1
     C                   Write     SDATA1
     C                   EndDo
     C                   Eval      #SFLRCD = Rrn
     C
     C                   If        PageUp <> *ON
     C                   If        Not $Next
     C                   Eval      EOF = *On
     C                   EndIf
     C                   IF        EOF = *On
     C                   Eval      SFLEND = *ON
     C                   Else
     C                   If        Not $FetPrior
     C                   Eval      EOF = *On
     C                   EndIf
     C                   EndIf
     C                   EndIf
     C                   Reset                   PageSize
     C                   EndSr            
      * 

Michael Smith
iSeries.mySeries.


-----Original Message-----
From: Buck Calabro [mailto:buck.calabro@xxxxxxxxxxxx] 
Sent: Thursday, July 08, 2004 1:12 PM
To: rpg400-l@xxxxxxxxxxxx
Subject: Re: Subfile problem


> I can see it being written to the subfile and
> the RRN is 12 at the point of the EXFMT.
> SFLDSP and SFLDSPCTL are on.

You have an interesting one.  Could you post some code, specifically
around loop that loads the subfile records and does the EXFMT?  Also,
what is the CPF/MCH number of the error messages you are getting?
  --buck



--
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing
list To post a message email: RPG400-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/rpg400-l
or email: RPG400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.