Re: MCH1210 error message

What you are saying is what i thought was the problem at first, and after
lookign at all the record counters for that subfile, they are all 4 digits
long and the subfile is at approx record number 6550.
I'll have another look at those variables.
Do you think that this could be a RPG400 problem rather than a problem with
my software?


It doesn't have to be the record counter field it could be some other field
that just happens to be record 6550.   Take a dump or run it in debug,

John








  jpcarr@tredegar.com wrote:
>Hello all,I am scrolling through subfile and program falls over at about
the 6550 record mark with error >message,"MCH1210 Receiver value too small
to hold result".When I press F1 over the message I just get the same >error
message again.Does any one have any ideas?Thanking you in advance,Mohan
>Mohan

First, I still can't believe people loading that many records in a
subfile. Didn't your fingers get tired?

Second, Sounds like you had something like EVAL A = B
and A is a smaller size than B and you tried to put something like 1000
into a 3 position field(or something similar)

John Carr