RE: Debug in ILE

["Lester S. Shaw" <lshaw@xxxxxxxxxx>]

Anita,

After entering the STRDBG command, set at least one breakpoint (type BREAK
XXXX on command line where XXXX represents line number OR F6 on line number
you would like to break on).  Then hit F12 to return to your command line.

Next call your program.

Hope that helps.

Lester

-----Original Message-----
From: rpg400-l-admin@midrange.com [mailto:rpg400-l-admin@midrange.com]On
Behalf Of Anita Imbrescia
Sent: Tuesday, December 11, 2001 12:45 PM
To: 'rpg400-l@midrange.com'
Subject: Debug in ILE


I am trying to write all new programs in ILE.  But I cannot use debug.  I am
trying to read the manual and have compiled it various ways, including:

CRTBNDRPG PGM(MYLIB/RPGPGM) DFTACTGRP(*NO) DBGVIEW(*SOURCE)ACTGRP(*NEW)

After playing around with this, I was able to view the source.

But, when I try to debug it, I use:

STRDBG (MYLIB/RPGPGM)

At this point, I select F10 to step through the program (I normally use
STRISDB).
This is when it returns me to where I was before the STRDBG command.

Can anyone shed any light?  Your help is appreciated.

Anita Imbrescia
_______________________________________________
This is the RPG programming on the AS400 / iSeries (RPG400-L) mailing list
To post a message email: RPG400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/rpg400-l
or email: RPG400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/rpg400-l.