Re: Inconsistency ?

[rob@xxxxxxxxx]

From the manual:

Factor 1, the search argument, must contain the key or >*>*>*>*>*relative
record number<*<*<*<*<* used to retrieve the record...

Therefore you were accessing by relative record number.  If RCCUS was equal
to 000003 then record 3 was unavailable or updated.  Are you sure that 'not
one' record was updated?

Rob Berendt

==================
Remember the Cole!


                                                                                
                                       
                    jjooste@omnia.co.                                           
                                       
                    za                       To:     RPG400-L@midrange.com      
                                       
                    Sent by:                 cc:                                
                                       
                    owner-rpg400-l@mi        Subject:     Inconsistency ?       
                                       
                    drange.com                                                  
                                       
                                                                                
                                       
                                                                                
                                       
                    10/25/00 09:00 AM                                           
                                       
                    Please respond to                                           
                                       
                    RPG400-L                                                    
                                       
                                                                                
                                       
                                                                                
                                       





Please can anybody give me advise on the weird situation.

FRARXX02   IP   E             DISK
FRCML01    UF   E             DISK
C***
C     RCCUS         CHAIN(E)  RCML01
C                     IF                 %FOUND AND NOT %ERROR
C               ADD           RAMT          CAMTD
C                    UPDATE(E)     IPR100CM
C                     ENDIF
C***

Reading a file, chaining to another file without a K specified, and
updating it.
When compiling the pgm, not even a severity 10 error. Debugging it, it
shows the
data moving into the correct field, interrupting it, it also shows the file
and
record being accessed and updated.

Problem: After running the pgm, not one record were updated ?

Changing the 2nd line to this: FRCML01    UF   E          K   DISK, with
the K
in place, it worked.

Am I going mad or what ?



+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---