Re: Time Math in RPGLE

[Rob Berendt <rob@xxxxxxxxx>]

I looked up the SUBDUR op code at:
http://publib.boulder.ibm.com/cgi-bin/bookmgr/BOOKS/QBKAQE01/4.4.87
See also duration codes at:
http://publib.boulder.ibm.com/cgi-bin/bookmgr/BOOKS/QBKAQE01/4.3.8

Will this work for you?  And these are V3R2 sites.





klemscot@klements.com on 07/31/2000 11:52:40 AM
Please respond to RPG400-L@midrange.com@Internet
To:     RPG400-L@midrange.com@Internet
cc:      
Fax to: 
Subject:        Re: Time Math in RPGLE


On my system (V3R2) it tells me that I need a duration entry in factor
two when I try to key this in.  This implies to me that (at least at V3R2)
you can't subtract two timestamps to get a time.

Also, what would it do if the timestamps were over a day apart?  Wouldnt
that cause a "receiver value is too small to hold result"?



On Sun, 30 Jul 2000, Anton [iso-8859-1] Gombk8t8 wrote:

> >Timestamps are data type "Z".  As far as I know, there isn't a direct way
> >to get "hours and minutes" between two timestamps
> 
> Oh, yes!
> 
> The result field of SUBDUR just has to be a time field!
> 
> C    TimeStampTo   SUBDUR   TimeStampFrom     TimeField
> 
> 0.02 Euro
> 
> Anton Gombk8t8
> 

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.comm
+---


+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---