Re: SETLL and SETGT

[booth@xxxxxxxxxxxx]

You can CHAIN to reset the file.

   C    1           Chain   File

would bring you to record number 1. 

You can also use *START and *END to Setll to a file.

_______________________
Booth Martin
Booth@MartinVT.com
http://www.MartinVT.com
_______________________




"hendry tionardi" <ahen75@hotmail.com>
Sent by: owner-rpg400-l@midrange.com
06/19/2000 10:58 PM
Please respond to RPG400-L

 
        To:     RPG400-L@midrange.com
        cc: 
        Subject:        SETLL and SETGT

I'm reading last record and then i reading again, and it's end of 
file.Then 
The indicator is on.
But then i'm using READP for set the pointer back, but cannot proceed.

>From the book i see if i read the last record and i read again, the 
result 
indicator is on, and for futher proceed i must using SETLL or SETGT then 
READP,READ statement can be used again.

But the file i'm using doesn't had KEY, so how can i'm using SETLL and 
SETGT??



________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: 
david@midrange.com
+---




+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---