RE: Quick Debug question

[Joel Fritz <JFritz@xxxxxxxxxxxxxxxx>]

If you don't want to set a break point when your're in the initial source
view, press F10 to leave and then call the program.  You'll go to the first
executable line.  I use it all the time for little test programs where other
people might use the dsply opcode.



> -----Original Message-----
> From: Jim Langston [mailto:jlangston@conexfreight.com]
> Sent: Wednesday, January 26, 2000 2:52 PM
> To: RPG400-L@midrange.com
> Subject: Quick Debug question
> 
> 
> When I do a STRDBG the system shows me the source code
> for my program.  I then add a breakpoint to the first line and do
> a F12, then run it and do tracing and such...
> 
> Well, this time I forgot to add the breakpoint, and ran the program.
> How do I get into the source code like I did initially?  I 
> tried looking
> 
> in the softcopy for STRDBG but it gave no mention how to do it.
> 
> Regards,
> 
> Jim Langston
> 
> +---
> | This is the RPG/400 Mailing List!
> | To submit a new message, send your mail to RPG400-L@midrange.com.
> | To subscribe to this list send email to RPG400-L-SUB@midrange.com.
> | To unsubscribe from this list send email to 
> RPG400-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: 
> david@midrange.com
> +---
> 
+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---