Re: Quick Debug question

Jim,

whenever you're looking for a command, just enter

go cmdxxx

where xxx is the part that you know.

If you enter GO CMDDBG, you'll step over DSPMODSRC. It is also shown when
you enter GO CMDDSP, but there are a lot more commands displaying something
than commands that have something to do with debug...

0.02 Euro

Anton Gombkötö

----- Original Message -----
From: "Jim Langston" <jlangston@conexfreight.com>
To: <RPG400-L@midrange.com>
Sent: Thursday, January 27, 2000 4:09 AM
Subject: Re: Quick Debug question


> Thank you all who replied with the command DSPMODSRC.
> Where is this documented?  Or is this one where I would have
> to search for, or happen to come across in the CL manual?
>
> I tried DSPD* (for display debug) and DSPR* (for display RPG)
> and a few others, didn't think of that one.
>
> Thanks again.
>
> Regards,
>
> Jim Langston
>
> David Gibbs wrote:
>
> > At 04:51 PM 01/26/2000 , Jim Langston wrote:
> > >Well, this time I forgot to add the breakpoint, and ran the program.
> > >How do I get into the source code like I did initially?  I tried
looking
> >
> > DSPMODSRC
> >
> > david
> >
> > --
> > | Internet: david@midrange.com
> > | WWW:      http://www.midrange.com/david
> > |
> > | This message was written and delivered using 100%
> > | post-consumer (recycled) data bits.
>
> +---
> | This is the RPG/400 Mailing List!
> | To submit a new message, send your mail to RPG400-L@midrange.com.
> | To subscribe to this list send email to RPG400-L-SUB@midrange.com.
> | To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---