Re: Display cross reference of file and programs

["alan shore" <SHOREA@xxxxxxxx>]

using the method you described and WRKCMD ANZ* resulted in the same list------ 
NO ANZPGM command.
We just recently upgraded to V4R3. I wonder if this is a problem due to the 
upgrade?

>>> Jim Langston <jlangston@conexfreight.com> 12/23 12:08 PM >>>
Woah!

I'm on V3R7M0 and ANZPGM is in library QSYS.
It is a standard OS/400 command as far as I know.
Perhaps they took it out for some reason?  Very
strange.

What happens when you try
ANZ* on the command line?

Regards,

Jim Langston

alan shore wrote:

> What release are you on. I am on V4R3 and I attempted to prompt on this 
>command and ithe response was
> Command ANZPGM in library *LIBL not found.
> Any suggestions? Is this a command that has been created in-house?

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com 
+---

+---
| This is the RPG/400 Mailing List!
| To submit a new message, send your mail to RPG400-L@midrange.com.
| To subscribe to this list send email to RPG400-L-SUB@midrange.com.
| To unsubscribe from this list send email to RPG400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---