×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
I see the loopback address (127.0.0.1) under IPv4 Interfaces, but IPv6 is empty.
-----Original Message-----
From: DrFranken [mailto:midrange@xxxxxxxxxxxx]
Sent: Wednesday, May 09, 2018 9:51 AM
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Subject: Re: IPv6, thought it was off
Check your startup job. We often start TCP in there and if the command is coded with STRIP6(*YES) then it starts. If your IPL Attribtes have
STRTCP(*YES) then it will use the defaults on the STRTCP command in QSYS.
Also check to see if perhaps your changed defaults are to a command in a different library than QSYS.
You will always have the IP6 loopback address ::1 just like you always have the IP4 address 127.0.0.1. As you suggest though it won't be running if you don't start it.
If you aren't using it though as you suggest not starting it IS the right answer.
- Larry "DrFranken" Bolhuis
www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
