Re: Network setup for sharing imagecatalog.

Good document there but one comment. They speak about adding host table entries but I've done a hundred of these easy and never added a host table entry for this even once.

- Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 5/4/2018 4:01 PM, Kevin Bucknum wrote:

Probably a better doc out there, but I'm working off of this one:

http://www-01.ibm.com/support/docview.wss?uid=nas8N1013479


I already have a virtual connection between my two lpars on the same
box.


F5 on both basically looks like this:


Resource name . . . . . . . : VLAN ID 0

Adapter type . . . . . . . : *NON

Adapter serial number . . . :


Host name for service tools :

Node . . . . . . . . . . . : 000000000000

Duplex . . . . . . . . . . : AUTO

Network speed . . . . . . . : AUTO


IP version allowed . . . . : BOTH IPV4, IPV6, BOTH

Internet address . . . . . : 0.0.0.0

Gateway router address . . : 0.0.0.1

Subnet mask . . . . . . . . : 255.255.255.0


IPV6 address . . . . . . . :

IPV6 interface ID . . . . . : 0000000000000000

DHCP unique ID . . . . . . : 0000000000000000000000000000


F13 lists no devices. F21 lists three resources. Those are currently
used by line configs pointing to DMZ, Internal network, and Virtual over
the backplane.


The way I read that doc what I can do is to end the virtual interface
and vary the line off. That will make it available to F13. From F13 I
can set up the new information. Can I use a different IP that is valid
across the virtual network? Once I'm done it reads like I can vary the
old virtual back on, and start the interface, and it should talk to both
IP's. Is my reading of that correct?