Re: New V7R3 LPP not being installed when using DSLO image

Exactly. Personally I think it's one of those options that 'just didn't occur to me' until I needed it then once discovered it's flatly obvious. You know the old 'face palm'.

Such as the case with CFGTCP option 10, check out '7'. Should have seen me the day I discovered that one!! :-)


- Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 1/19/2018 7:31 AM, Rob Berendt wrote:

Been that way, documented, for a long time. Here it is from 6.1 (which
was easy to go back to in the Knowledge Center).
https://www.ibm.com/support/knowledgecenter/ssw_ibm_i_61/rzahc/contlp.htm

A licensed program you want to install might not be listed on the Install
Licensed Programs display. If a licensed program is not listed, it can be
added to the list by entering information into the blank fields at the top
of the list. After you press Enter, this product then appears on the list
with the other products.
Type 1 in the Option column.
Type the product identifier in the Licensed Program column.
Type the product option value in the Product Option column.
Press Enter.

It's a character for character match with 7.3.

Rob Berendt