Re: How to cable two ESLS disk expansion units to our new EMX0 expansion unit.

Personally unless you can see NO use for that removed card I would place it in C1 or C6 of this expansion. If it's Ethernet cable it too so that if you need it no trip to Barden is required!

- Larry "DrFranken" Bolhuis

www.Frankeni.com
www.iDevCloud.com - Personal Development IBM i timeshare service.
www.iInTheCloud.com - Commercial IBM i Cloud Hosting.

On 7/19/2017 9:19 AM, Rob Berendt wrote:

Ok. I will move C3 to C2 and C6 to C5.
And I believe you're right on the "every card is it's own bus now" so it
shouldn't matter if I wire
C1-C2 and C4-C5 vs
C1-C4 and C2-C5

Knowledge gained here will be applied to our second similar upgrade. The
difference being the first system is a 41A and the second one will be a
42A. On both I will be ripping out an unused card from C10 and replacing
it with the EJ08 card.


Rob Berendt