RE: Power7 57B58150

Power off/restart is the easiest. You could also remove the cards from the
configuration, use SST to power them off, power them back on and add them
back into the configuration. That is only a procedure you should attempt if
you understand how to power off/on domains in SST/DST.

Also, if the AA cable was inserted into that card with the system running
and power applied to the card, it could have damaged the card, therefore
throwing the errors you see. IBM hardware support may have to do advanced
diagnostics to figure out if that happened. Those cards are not designed
for hot plug of the cabling.

--
Jim Oberholtzer
Chief Technical Architect
Agile Technology Architects


-----Original Message-----
From: MIDRANGE-L [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Holger Scherer
Sent: Sunday, June 21, 2015 9:47 AM
To: Midrange Systems Technical Discussion
Subject: Re: Power7 57B58150


Additional note - talked with some of the technicians here. one states it
may be possible they powered up the box without the AA cable (which i think
will fire up that error). Maybe we just need to reset the degraded mode -
question is: how :)

-h



Am 21.06.15 um 16:30 schrieb Pete Massiello - ML:

Do you have it cabled correctly.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at http://archive.midrange.com/midrange-l.