Rob,

Thanks for your suggestions
Given that I have over 80 "Not Applied" PTFs this sounds like a time consuming project :(

John

-----Original Message-----
From: rob@xxxxxxxxx [mailto:rob@xxxxxxxxx]
Sent: Thursday, December 04, 2014 7:03 AM
To: Midrange Systems Technical Discussion
Subject: RE: After installing Group PTF SF99610 it still shows as Not Installed

+1 to Jim's suggesions. I want to add that sometimes a CHKPRDOPT may
point out some stuff. I actually have that documented in our instructions to be performed after PTF application as it sometimes now reports the product in error and that certain PTFs need to be applied. Pasting these instructions loses the formatting in this list but here goes:
CHKPRDOPT PRDID(*OPSYS)
Could take 2-13 minutes to run. Seen it run 39 minutes on GDISYS2 3/7/13, but that one did kind of freak me out and I opened a pmr (69150,082).
If you get “Errors found by CHKPRDOPT.” then hit F1 on that message to do a DSPJOBLOG and see what is the matter.
Sample error that once affected all lpars:
Required PTF 5770SS1-SI37877 V7R1M0 not in correct status for PTF
5770SS1-SI37171 V7R1M0.
Program temporary fix (PTF) 5770SS1-SI37171 V7R1M0 requires PTF
5770SS1-SI37877 V7R1M0 to be temporarily or permanently applied.
I ended up doing:
APYPTF LICPGM(5770SS1) SELECT(SI38389 SI37877) APY(*PERM) Repeat CHKPRDOPT until clean. Sometimes applying one ptf frees up another error, as you can see by the later addition of SI38389 above.


Rob Berendt
--
IBM Certified System Administrator - IBM i 6.1 Group Dekko Dept 1600 Mail to: 2505 Dekko Drive
Garrett, IN 46738
Ship to: Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com



This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].