×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Not unless you have multiple lines with virtual IP redundancy. You are
changing something at Layer 0 in the network so that will necessitate
that the line be varied off and back on, which of course means that any
IP interfaces ON THAT LINE will also have to be restarted as well.
Virtual IP addresses that can float to another line while this one is
down are not affected.
When making such changes be sure to verify that the speed and duplex
that the i reports and speed and duplex the switch reports are
identical. Also while you're at it, change the CMNRCYLMT parm to (1 0)
giving you infinite retries on that line.
- Larry "DrFranken" Bolhuis
On 9/26/2011 2:16 PM, fbocch2595@xxxxxxx wrote:
Hi Folks, another question for you. I've noticed that some of my lines show 100M/half and I'd like them to run at 1G/full like the other interfaces. I'd like to make the changes without ending tcp, if possible. So, is it possible to make these changes without having to endtcp?
Thanks, Frank
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
