×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
We just upgraded to a Power 7 box a week ago, so this is our first
exposure to using a HMC. Previously we had a twinax attached Console.
We are running V7R7.2.0.1 of HMC. The HMC is located offsite.
Now the problem I'm having is that I create a 5250 session to the
console, but it will timeout after about 90 minutes with the following
messages.
CPF5140 Session stopped by a request from device DSP01.
CPF2677 Device DSP01 no longer communicating
This is not terrible except that we use a custom System Save. The
system save is started on DSP01 and waits until a message is sent from
the job scheduler to start the save. We can't get this to work now
because of the timeout. How can I prevent the Console from timing out?
I guess as a side question, Is it still a requirement that the system
save run from a Console?
Thanks.
Mike
NOTICE: This message, including any attachment, is intended as a confidential and privileged communication. If you have received this message in error, or are not the named recipient(s), please immediately notify the sender and delete this message.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
