×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
I have done a Save 21 and then replaced all the drives on this system
with larger drives. I restored the LIC and then configured the drives
(RAID5) started parity protection and then restored the operating
system. At that point, I began a RESTORE 21 to restore the remaining
data on the system. The RSTLIB failed which caused the RESTORE 21 to
abort with the following:
1 libraries had security or integrity changes
210 libraries restored; 8 partially restored; 0 not restored.
CPF3779 received during RSTLIB command. (CG)
?C
The C response must have been an autoreply since I didn't (and wouldn't
have) take that option.
Going through the job log, there really isn't anything fatal. A few
configuration objects didn't restore (TAP01, PRT01, PRT02, etc)
presumably because autoconfiguration recreated them. But nothing else
out of the ordinary was in the job log.
Is the CPF error enough to cancel the whole shebang? Should I just
proceed with the RSTDLO, RST and RSTAUT commands that the Backup and
Recovery guide say are part of the RESTORE 21 option? I am kind of
stumped here. I have never restored a system from a SAVE 21 before so
this is new territory for me.
Pete
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
