×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Bonnie,
I sure hope you have a two or four core 8203, because if it is a one
core, you can't put any additional towers on it. You can only put an IOP in
an older HSL-2 attached tower, which is required to drive the IOA (2793 or
similar) for the SDLC protocol to be enabled on the card.
Pete
Pete Massiello
iTech Solutions
http://www.itechsol.com
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Bonnie Lokenvitz
Sent: Friday, July 31, 2009 1:33 PM
To: Midrange Systems Technical Discussion
Subject: V5R4 8203 SDLC Replacement
We have just installed a 520 8203 model E4A that replaces our 520 9405.
Our IBM business partner (who shall again remain nameless) was to
configure it so we would lose no capabilities but we can no longer use
SDLC without adding an expansion unit and cards.
We use SDLC to dial into clients' AS/400s . Many of these small clients
are on older models and most have little or no IT staff.
Is there an alternative to SDLC that will still allow i5 to AS/400
connectivity and would not require too much configuration on the target
system
Thank you,
Bonnie Lokenvitz
midrange.com
