Are you looking at all the controllers?
Could be more than one.
Norm Dennis
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jerry Adams
Sent: Tuesday, 9 June 2009 8:40 PM
To: Midrange Systems Technical Discussion
Subject: Twinax Device Addresses
We still have a few twinax line printers here. They are connected to the
System i via an Ethernet patch panel; the twinax control is connected to the
panel with a balun and Ethernet cable.
Pretty rudimentary stuff, I think. My question is: Why, when I run the
PRTDEVADR command these printers do not show up? In fact, the only thing
that shows up in the list is the old system console at port 0 address 0.
Jerry C. Adams
IBM System i Programmer/Analyst
--
B&W Wholesale
office: 615-995-7024
email: jerry@xxxxxxxxxxxxxxx
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2026 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
