RE: Twinax Device Addresses

That is the name of the Hardware Resource. Do a WRKCTLD CTL* and I bet you
will see the two Controller descriptions that point to the hardware
resource. You want to use the controller descriptions to get the device
addresses.

Pete

Pete Massiello
iTech Solutions
http://www.itechsol.com



-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jerry Adams
Sent: Tuesday, June 09, 2009 10:16 AM
To: Midrange Systems Technical Discussion
Subject: RE: Twinax Device Addresses

When I GO HARDWARE and run " 2. Work with local workstation resources," I
see two controllers: CTL03 and CTL05. But there's only one "loon" (brick)
coming out of the back of the 520. There are five [5] of these old twinax
dot matrix printers; they are all used (to varying degrees) and all of them
show up when I run WRKCFGSTS *DEV.

When I run PRTDEVADR against CTL03, I get a message that " Controller CTL03
not found" (CPF2602). My set-up is identical to that described by Loyd.

I know that there are two printers configured for Port 1 because I looked at
their configuration. This whole question started, in fact, because I had to
swap these printers out yesterday, and I was looking for an unused address
on the port that I could use temporarily for one of them so I could change
the configuration without having to muck around with those DIP switches.

Thanks.

Jerry C. Adams
IBM System i Programmer/Analyst
--
B&W Wholesale
office: 615-995-7024
email: jerry@xxxxxxxxxxxxxxx


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Pete Massiello
Sent: Tuesday, June 09, 2009 7:53 AM
To: 'Midrange Systems Technical Discussion'
Subject: RE: Twinax Device Addresses

Do you have multiple Twinax controllers?

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jerry Adams
Sent: Tuesday, June 09, 2009 8:40 AM
To: Midrange Systems Technical Discussion
Subject: Twinax Device Addresses

We still have a few twinax line printers here. They are connected to the
System i via an Ethernet patch panel; the twinax control is connected to the
panel with a balun and Ethernet cable.

Pretty rudimentary stuff, I think. My question is: Why, when I run the
PRTDEVADR command these printers do not show up? In fact, the only thing
that shows up in the list is the old system console at port 0 address 0.

Jerry C. Adams
IBM System i Programmer/Analyst
--
B&W Wholesale
office: 615-995-7024
email: jerry@xxxxxxxxxxxxxxx