Hi,
When starting with ILE (concepts) the following redbook may be really
helpful:
Who Knew You Could Do That with RPG IV? A Sorcerer's Guide to System Access
and More
http://www.redbooks.ibm.com/abstracts/sg245402.html?Open
This redbook is AFAIK based on release V4R5, so there will be nothing that
cannot be used with release V5R1.
For additional information check the IBM info center (as others already
suggested).
Mit freundlichen Grüßen / Best regards
Birgitta Hauser
"Shoot for the moon, even if you miss, you'll land among the stars." (Les
Brown)
"If you think education is expensive, try ignorance." (Derek Bok)
"What is worse than training your staff and losing them? Not training them
and keeping them!"
-----Ursprüngliche Nachricht-----
Von: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] Im Auftrag von Al
Gesendet: Sunday, 10. May 2009 20:03
An: 'Midrange Systems Technical Discussion'
Betreff: ILE Novice
Can someone point me to link to manual on RPGLE?
One thing that might be helpful would be what you can / cannot do in RPG vs.
RPGLE.
I am on V5R1, tried to do something with RPG, could not get everything
needed, copied source code to RPGLE, planning to identify & fix any errors,
then work on what I could not do in RPG, only 1,000 errors in the compile
was a bit more than I bargained for. I suspect/hope most is due to F
specifications structured differently.
I assume the PDM Type is correct for me.
RPG becomes RPGLE and
SQLRPG becomes SQLRPGLE
When calling an RPGLE program, can I do it with CL (in QCLSRC), or do I need
to use CLE (in what source name)?
I am using files defined in DDS . I sure hope externally defined files work
same way in RPGLE as in RPG.
-
Al Macintyre
-
Home PC in midst of replacement ... many standard things not yet fully
operational again yet
midrange.com
