|
You can turn sleep mode off in the resets submenu.
as400 wrote:
I have an HP LaserJet 4250tn set up as an ip printer.
It works fine with one minor annoyance. If the printer is in sleep mode
when it receives a job the following message appears in QSYSOPR on a
520 running V5R4:
Message ID . . . . . . : CPI404F
Message . . . . : Problem with device PRT08.
Cause . . . . . : An error was detected on device PRT08. Look at the
printer to determine the cause of the problem.
This is a severity 99 message, which causes somebody to investigate.
However, the printer prints the job without a problem.
On a 270 running V5R3 I also get a message in QSYSOPR, but a less
severe one:
Message ID . . . . . . : CPD337F
Message . . . . : Remote device rejected an attempt by the writer to
open a connection.
This is a severity 40 message and therefore much less intrusive.
So my question: How can I avoid this message altogether, or if this is
not possible how can I get the less intrusive V5R3 behaviour on the V5R4
box?
Here's the *DEVD:
CRTDEVPRT DEVD(PRT08)
DEVCLS(*LAN)
TYPE(3812)
MODEL(1)
LANATTACH(*IP)
PORT(9100)
ONLINE(*YES)
FONT(11)
PRTERRMSG(*INFO)
INACTTMR(*ATTACH)
TRANSFORM(*YES)
MFRTYPMDL(*HP4000)
PPRSRC1(*A4)
PPRSRC2(*A4)
RMTLOCNAME('10.0.1.43')
SYSDRVPGM(*HPPJLDRV)
TEXT('HP LaserJet 4250tn')
WSCST(QGPL/HPLJ42)
Regards,
Moe
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.