Re: IP printer annoyance

[Wayne McAlpine <wayne.mcalpine@xxxxxxxxxxxxxxxxx>]

You can turn sleep mode off in the resets submenu.

as400 wrote:
> I have an HP LaserJet 4250tn set up as an ip printer.
> It works fine with one minor annoyance. If the printer is in sleep mode 
> when it receives a job the following message appears in QSYSOPR on a 
> 520 running V5R4:
>
> Message ID . . . . . . :   CPI404F
> Message . . . . :   Problem with device PRT08. 
>
> Cause . . . . . :   An error was detected on device PRT08.  Look at the
>    printer to determine the cause of the problem. 
>
>
> This is a severity 99 message, which causes somebody to investigate. 
> However, the printer prints the job without a problem.
>
>
> On a 270 running V5R3 I also get a message in QSYSOPR, but a less 
> severe one:
>
> Message ID . . . . . . :   CPD337F 
> Message . . . . :   Remote device rejected an attempt by the writer to 
> open a connection.
>
> This is a severity 40 message and therefore much less intrusive. 
>
>
> So my question: How can I avoid this message altogether, or if this is 
> not possible how can I get the less intrusive V5R3 behaviour on the V5R4 
> box?
>
> Here's the *DEVD:
> CRTDEVPRT DEVD(PRT08)
>            DEVCLS(*LAN)
>            TYPE(3812)
>            MODEL(1)
>            LANATTACH(*IP)
>            PORT(9100)
>            ONLINE(*YES)
>            FONT(11)
>            PRTERRMSG(*INFO)
>            INACTTMR(*ATTACH)
>            TRANSFORM(*YES)
>            MFRTYPMDL(*HP4000)
>            PPRSRC1(*A4)
>            PPRSRC2(*A4)
>            RMTLOCNAME('10.0.1.43')
>            SYSDRVPGM(*HPPJLDRV)
>            TEXT('HP LaserJet 4250tn')
>            WSCST(QGPL/HPLJ42)
>
> Regards,
> Moe