× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. MIDRANGE-L
  3. May 2006

Operations Console Cable

So much for an "easy" thing to do.

 

We just got in an ops console cable to use in replacing out old 5250
console.    Hooking up a 9406-800 @ V5R3.

 

I ran the cable from the 800 to the PC serial port, turned on auto
config, ran through the wizard on the ops console set up and can't get a
connection (according to the ops console screen on the PC) even after an
IPL.

 

A couple/few questions:

 

Do I need to remove the 5250 device from address 0 port 0?

Do I need to configure anything manually on the iSeries side? 

Any other words of wisdom?

 

I did follow the instructions at
http://publib.boulder.ibm.com/infocenter/iseries/v5r3/index.jsp?topic=/r
zam9/rzam952l02.htm 

 

David Smith

IT Consultant

As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.