Re: No signon screen

[rob@xxxxxxxxx]

I swore I had all those set right in the past and it still created the 
device descriptions.  But I sure can't duplicate it now.

Rob Berendt
-- 
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





Simon Coulter <shc@xxxxxxxxxxxxxxxxx> 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
04/19/2005 11:34 PM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
cc

Subject
Re: No signon screen







On 20/04/2005, at 1:16 AM, rob@xxxxxxxxx wrote:

> Autoconfig is a meaningless system value.  Client access, nor anything
> else, uses it.  They all run CRTDEVDSP under the covers.  I found out 
> the
> hard way.  I set autoconfig off on one machine.  iSeries Access users 
> were
> still able to configure sessions until I renamed the command CRTDEVDSP 
> to
> CRTDEVDSPX.  That stopped them.

It's not meaningless. QAUTOCFG controls auto-configuration of local 
controllers and devices i.e., twinax-displays and printers. Just 
because you may not have any of them doesn't remove the inherent 
meaning.

The other interfaces you mention are controlled by QAUTOVRT (as long as 
they create a virtual device).

QAUTORMT handles remote controller configuration.

This separation provides granularity of control--even if it is found 
confusing.

Regards,
Simon Coulter.
--------------------------------------------------------------------
    FlyByNight Software         AS/400 Technical Specialists

    http://www.flybynight.com.au/
    Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
    Fax:   +61 3 9419 0175                                   \ /
                                                              X
                  ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------


-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.