RE: Separate subsystems

[ron_adams@xxxxxxxxxxxxxx]

You can separate who goes to which subsystem using the Add Workstation 
Entry (ADDWSE) command.

On the command, you can specify either Workstation name such as  ACCT* or 
DAVE*   or you can specify the Workstation Type such as 3180, CONS, 
*ASCII, etc.

Ron Adams






Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>
Sent by: midrange-l-bounces@xxxxxxxxxxxx
04/18/2005 01:10 PM
Please respond to Midrange Systems Technical Discussion

 
        To:     "'Midrange Systems Technical Discussion'" 
<midrange-l@xxxxxxxxxxxx>
        cc: 
        Subject:        RE: Separate subsystems


By using Named devices you can specify which subsystem picks up the device
at signon by adding a workstation name entry.  For instance to put all 
ACCT
devices into QINTER1, not QINTER2 you would add a workstation name ACCT*
@signon to QINTER1 and ACCT* @enter to QINTER2.


-----Original Message-----

I have been asked by a client to create separate subsystems for their
interactive users.

I have done this before but am drawing a blank as to how to direct the 
users
to the correct subsystem.  Some of the users have unique device names such
as DAVE1 but others are still using QPADEV* taype names

How do I direct the users to the correct subsystem or where can I go to
learn the process gain
-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.