Re: System Reference Codes on a 170

[Philipp Rusch <philipp.rusch@xxxxxxxxxxxx>]

Correction: the function 21 is needed to bring up DST.
Sorry for this confusion.

Philipp Rusch schrieb:

> Hello Chris,
>
> I assume you are using V5 of OS/400, where the passwords for
> DST-users are case-sensitive (!).
> Defaults are:   QSECOFR - QSECOFR, 22222222 - 22222222  (8x 2)
>
> Now you are about to reclaim IOP cache storage:
>
> inside DST menus select "work with disk units" ,
> go to "Reclaim IOP storage" and follow that procedure
> (there is online help available)
> the system will do an IPL ...
> display the disk warning report
> and then you will need a second "Reclaim IOP storage"
> when IPL was done from D, this is a normal procedure at
> this stage.
> There may be some warnings about lost disk sectors or so,
> sometimes the ASP has to be cleared to go on.
>
> There is a 15 minutes delay for the next IPL to complete,
> so be patient.
> If the system stops at A600 5082, you need to go to Function
> 12 on the front panel to get back to DST.
> Do not shutdown the system !
>
> Greets, Philipp
>
>
> Chris Spirinckx schrieb:
>
> > On Mon, 31 May 2004 14:40:07 +0200, you wrote:
> >
> >
> >
> >
> > Hi Philipp,
> >
> >
> > Sorry that it took a while...
> > Not having any CD, I had to do a manual IPL from the D-side using the 
> > Systemsave on a QicTape.
> >
> > I now have the "Install licenced Internal code" menu
> > and selected option 2 ( DST )
> >
> > Here he asks for the DST user and password.
> > At the bottom of the screen there is the message :
> > "Cannot access user profiles - defaults are in effect"
> >
> > Entering QSECOFR & 222222 gives "invalid password".
> >
> >
> > Any suggestions ?
> >
> >
> > Chris
> >
> > --