|
We have the same problem at my shop, cursor moves, but no command keys or the enter key works. I once solved it (from the Communication menu of the session) with disconnecting and connecting the session again; it meant to re-signon to the system. Although I have not tried this: perhaps asking system management to disconnect your job (option 14 in WRKACTJOB), then disconnect and connect your session again. After signing on you should be in the same place where you left off. Hopefully all keys respond as they should do. Regards, Carel Teijgeler *********** REPLY SEPARATOR *********** On 15-3-04 at 12:43 pat wrote: >By "locking up", I mean that session is "done". You have to actually close >that session down. The cursor still blinks and you can move it around, but >you cannot type anymore commands or function keys. The reset does not work.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
