Changing Command Defaults

Folks --

Hopefully, this is an easy one.

I have created a duplicate of WRKACTJOB and called it WAB.  My intent is to 
have it only display the batch subsystems.  However, I can't seem to execute 
the CHGCMDDFT command.

CHGCMDDFT CMD(WAB) NEWDFT('SBS(QBATCH MIS)')

gets the following message . . .

 Message ID . . . . . . :   CPD6267       Severity . . . . . . . :   40         
 Message type . . . . . :   Diagnostic                                          
 Date sent  . . . . . . :   05/02/03      Time sent  . . . . . . :   10:55:01   
                                                                                
 Message . . . . :   Cannot specify keyword default value more than once.       
 Cause . . . . . :   Keyword SBS is defined as a list of values, and keyword    
   SBS had more than one value specified for the same list item or qualifier.   
 Recovery  . . . :   Omit all but one value or list of values to be used as the 
   default for the qualified name or the new list.                              

I would like to be able to do this, and also to put the CRTDUPOBJ and CHGCMDDFT 
into my "rebuild customizations" CL program that I made after a discussion a 
few weeks ago here.

If I can't get this to work then I will make a one-line CL program.

Any help would be appreciated.

THIS MESSAGE IS INTENDED ONLY FOR THE USE OF THE INDIVIDUAL OR ENTITY TO WHICH 
IT IS ADDRESSED AND MAY CONTAIN INFORMATION THAT IS PRIVILEGED, CONFIDENTIAL 
AND EXEMPT FROM DISCLOSURE UNDER APPLICABLE LAW.  If the reader of this message 
is not the intended recipient, or the employee or agent responsible for 
delivering the message to the intended recipient, you are hereby notified that 
any dissemination, distribution, copying, downloading, storing or forwarding of 
this communication is prohibited.  If you have received this communication in 
error, please notify us immediately via email and delete the message from your 
computer files and/or data base.  Thank you.