Re: Changing Command Defaults

[Vern Hamberg <vhamberg@xxxxxxxxxxxxxxxxxxxxxxxxx>]

The default value for a parameter cannot be a list, for one thing. Look at 
the DFT keyword in command source. You could have it be only QBATCH or only 
MIS but not both.

HTH

Vern

At 11:01 AM 5/2/2003 -0700, you wrote:
> Folks --
>
> Hopefully, this is an easy one.
>
> I have created a duplicate of WRKACTJOB and called it WAB.  My intent is 
> to have it only display the batch subsystems.  However, I can't seem to 
> execute the CHGCMDDFT command.
>
> CHGCMDDFT CMD(WAB) NEWDFT('SBS(QBATCH MIS)')
>
> gets the following message . . .
>
>  Message ID . . . . . . :   CPD6267       Severity . . . . . . . 
> :   40
>  Message type . . . . . 
> :   Diagnostic
>  Date sent  . . . . . . :   05/02/03      Time sent  . . . . . . 
> :   10:55:01
>
>
>  Message . . . . :   Cannot specify keyword default value more than 
> once.
>  Cause . . . . . :   Keyword SBS is defined as a list of values, and 
> keyword
>    SBS had more than one value specified for the same list item or 
> qualifier.
>  Recovery  . . . :   Omit all but one value or list of values to be used 
> as the
>    default for the qualified name or the new 
> list.
>
> I would like to be able to do this, and also to put the CRTDUPOBJ and 
> CHGCMDDFT into my "rebuild customizations" CL program that I made after a 
> discussion a few weeks ago here.
>
> If I can't get this to work then I will make a one-line CL program.
>
> Any help would be appreciated.