RE: Configuring a backup ethernet line -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

What I did is create a separate IP for each line.  Then I created a Virtual
IP.  I put the VIP into DNS and WINS.  I added two routes to the VIP in our
default router.  The VIP must be on a separate subnet as the physical IP.
This also gives OS400 the ability to do outbound load balancing on both
Ethernet lines.  Each Ethernet is plugged into a different switch and soon
to be on different subnets.

Christopher K. Bipes      mailto:Chris.Bipes@xxxxxxxxxxxxxxx
Operations & Network Mgr  mailto:Chris_Bipes@xxxxxxxxx
CrossCheck, Inc.          http://www.cross-check.com
6119 State Farm Drive     Phone: 707 586-0551 x 1102
Rohnert Park CA  94928    Fax: 707 586-1884


-----Original Message-----
From: York, Albert [mailto:albert.york@xxxxxxxxxxxxxx]

I have an AS/400 with two ethernet lines. The second line is intended to
back up the first line. Each line will connect to the LAN through different
switches. The intention is if the first line or switch fails then the AS/400
(and all incoming traffic) will automatically use the second one. How do I
configure that? To create an interface do I need an IP address for each
line?

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.