Switching Universal Connection transport.

["Roger Vicker, CCP" <rvicker@xxxxxxxxxx>]

Hello,

I've got a college with a 270 at V5R1 Cume 2134. The system used to have 
a public address and used the internet for ECS.

They finally switched their firewall to a Sonicwall and now the iSeries 
has a private address with the old public address being NAT'ed through 
the firewall. Since the Universal Connection at V5R1 doesn't deal with 
firewalls I tried to switch to the internal modem on the 2771. After 
filling out the wizard in OpsNav (as a QSECOFR) I got the error "An 
error occurred saving data: Sharing violation occurred." It then asked 
if I wanted to test the connection. The test was successful but if I use 
SNDPTFORD the job log shows that it tries to use the QTOCL2TP and 
QESLINE (SDLC) but not the new QESDIAL.

Has anyone seen this before or know how to clear the sharing violation 
so ECS functions will use the correct hardware?

BTW I found out the hard way that before I run the wizard again to 
delete QESDIAL first. If I don't the wizard creates a duplicate profile 
and then practically nothing works (even delete) until an IPL cleans one 
of them out.

Thanks.

Roger Vicker, CCP

--
*** Vicker Programming and Service *** Have bits will byte *** www.vicker.com 
***
All Scotch cuisine is based on a dare.